Audio-Technica AT-ART7

$1,090.00


Description

Based on the limited-edition AT50ANV premium moving coil cartridge, the AT-ART7 features the same basic design but exchanges the titanium armature (coil-winding frame) for a liquid crystal polymer armature, which is both thinner and stronger and does a better job of suppressing the unwanted vibration from power generation. The cartridge’s magnetic circuit uses a large-sized neodymium magnet and is designed to maximize the strength of the intensive magnetic field in the coil gap, increasing the output voltage and enhancing playback of medium-to-low frequencies. The result is extremely natural, three-dimensional sound quality.

The cartridge’s special line contact stylus, with a 40 µm × 7 µm curvature radius and a 0.26 mm diameter solid boron cantilever, enables an extremely accurate reading of the record groove and faithful transfer of the signal from the stylus tip to the magnetic coil. The dual moving coil (fashioned from high-performance PCOCC wire) offers excellent stereo separation and improved frequency response for long-lasting performance.

The hybrid housing of machined aluminum and hard plastic, along with the machined aluminum base supporting the magnetic circuit and vibration system, reduces unwanted resonance and provides stable playback.

Frequency Response 15-50,000 Hz
Channel Separation 30 (dB at 1 kHz)
Vertical Tracking Angle 23°
Vertical Tracking Force 1.6-2.0 g (1.8 g standard)
Stylus Construction Nude square shank
Recommended Load Impedance Min. 100 ohms
Coil Impedance 12 ohms (1 kHz)
DC Resistance 12 ohms
Coil Inductance 8 µH (1 kHz)
Output 0.12 mV (1 kHz, 5 cm/sec.)
Channel Balance 0.5 dB (1 kHz)
Stylus Shape Special line contact
Cantilever 0.26 mm diameter solid boron
Static Compliance 35 x 10-6 cm/dyne
Dynamic Compliance 10 x 10-6 cm/dyne (100 Hz)
Mount Half-inch
Weight 8.5 g (0.30 oz)
Dimensions 17.3 mm (0.68″) H × 17.0 mm (0.67″) W × 25.6 mm (1.01″) D
Accessories Included Non-magnetic screwdriver; 2 washers; 2 nuts; cartridge installation screws (12 mm × 2, 18 mm × 2); plastic protector; brush; AT6101 PCOCC lead wire set

 


Note: moving coil cartridges require receivers or preamps with compatible inputs; their stylus assemblies are not field-replaceable.

Read More
SKU ATART91923-1
Categories